Lab 1
Assessment Questions 1. What Cisco “show” command displays various information and details about the router or switch such as Model #, flash memory, RAM, IOS version and physical interfaces? a. Show version 2. During the Instructor’s TELNET session to LAN Switch 1 and LAN Switch 2, - What was the captured terminal password for LAN Switch 1 and LAN Switch 2? b. Cisco 3. What is the size of the IOS file used for the Cisco 28xx Routers? c. 239Kb 4. What is the command used to enter the global configuration mode for interfaces on a Cisco Router or Switch? d. Router >enable 5. The default hexadecimal value of the configuration register setting for the Cisco 28xx Router is? e. 0x2102 6. What are the specific settings for the configuration hexadecimal value 0x2102? f. ignores break g. boots into ROM if initial boot fails h. 9600 console baud rate default value for most platforms 7. What is the key sequence used to interrupt the boot sequence for the router and initiate the password recovery sequence? i. Pause/break key on the keyboard 8. Using the password recovery process how can you break the router boot sequence to see the router saved passwords and what can you do in that mode? j. Ctrl – C to skip to the initial setup procedure to view, change and delete passwords 9. What is the command used to back up the running-config file to TFTP? k. “copy running – config TFTP” 10. What process takes place if the command “copy tftp running-config” is entered? l. Allows you to merge your back up and your running running-config on the TFTP