Types of Flower Arrangement

By: Mylene B. Bataanon
BSTrm-II

1.)Horizontal Arrangements

Using a relatively shallow container, anchor foam with a lot of glue or use anchor pins, and position sprays of line flowers to establish the shape of the design.

Insert focal flowers in the middle so they gently droop over the lip of the container on both sides, reach towards the line material and extend on either side of the middle. Leave room for filler flowers.

Fill in and around focal area with filler flowers and foliage.

2.)Vertical Arrangements

Wedge or secure foam in a vase with hot glue. Cut the stems of the tallest flowers or leaves to reach three or four times the height of the vase. Place the focal flowers vertically within the diameter of the vase. Fill in the areas as needed with filler flowers. 3.)Triangular Arrangements

Secure floral foam. Determine the vertical height and horizontal width with the smallest line flowers and/or leaves. Make the height higher than the width.

Position the largest focal flowers in the heart of the arrangement and slightly lower to give weight and balance.

Fill in with the filler flowers and foliage keeping within the triangular shape.

4.)Crescent Arrangements

Secure foam in container. Determine length of crescent and insert curved line flowers or leaves to follow the crescent form. Angle the shape to balance in the container.

Insert the focal flowers fairly low in the bowl to achieve balance, stability and depth.

Fill in around the focal flowers with smaller flowers and foliage. Place wisps of filler flowers that gracefully taper off the ends.

5.)Oval Arrangements

Secure the floral foam. Determine the height with line flowers, then frame in the outer edges of the oval shape with light colored flowers and foliage.

Fill in around the larger flowers and leaves with the filler flowers.

6.)Minimal Arrangement

Adhere foam to container. Insert vertical line flowers to determine the height, and secure the horizontal line flowers to give the basic outline of the arrangement.

Place the focal flowers.

Fill in with filler flowers as needed.

7.)The lazy "S" or "Hogarth's Curve"

Anchor the foam securely. Bend the stems gently into graceful curves and insert them in place so they balance.

Add the focal flowers following the lines of the upper and lower curves.

Cluster filler blossoms and foliage around the central flowers maintaining the rhythm of the ‘S’. 8.)Free Standing Arrangements

Fill a shallow container with foam that extends one inch over the top. Secure the foam with hot glue, floral clay or floral tape. Define the shape of the design with the line flowers and leaves.

Place the focal flowers and leaves, turning the vase as you go so all the sides are even.

Add filler flowers to integrate the design.