Electrical Theory

Page 44 of 50 - About 500 Essays
  • Premium Essay

    Induction Motors

    motors can be used in situations where constant speed drive is required. Chapter IV EPM1076 3 Chapter IV EPM1076 4 Angle in Electrical and Mechanical Unit -For 2 pole machine, when the rotor rotates for one revolution, the induce emf varies for one cycle. i.e. θ = θm, (refer to figure 2) -Where θ is the angle in electrical degrees or radians and θm is the mechanical angle. - For a 4 pole machine, as the rotor rotates for one revolution (θm = 2π), the induced emf varies

    Words: 2662 - Pages: 11

  • Free Essay

    Literacy

    Jennifer L. Theresa Scott ENC 1101: Comp 1 June 8th, 2016 The Machines of Tomorrow Technology is everywhere. You go out in public and all you see is everyone concentrating on their phones. Technology allows people to communicate with one another and share information. Even if someone doesn’t own a computer or a phone, there is some type of mobile device, computer, or even television that you can get too to get the latest news. I was born in 1999, where technology wasn’t as big as it is now

    Words: 825 - Pages: 4

  • Premium Essay

    Unit 10. Assignment 1. Fiber- Optic Installation

    you are installing cable in conduits within a structure, be sure that you have allowed enough room for the cable or cables you are installing. Tray and duct installation is used inside structures and is similar to installation methods used for electrical wiring. Because many optical fiber cables are nonconductive, some of the requirements and restrictions for copper do not apply to fiber. When the optical fiber rests in trays or horizontal ductwork the weight of the cable is usually not a factor

    Words: 255 - Pages: 2

  • Premium Essay

    Physics Lab Ch. 20

    Name LC – Lab 20 Go to http://phet.colorado.edu/en/simulation/circuit-construction-kit-ac and click on Run Now. Arrange the circuit according the diagram below: You may have to replace the red and black voltmeter connections to the proper location in the circuit. a. Charge the capacitor by closing the switch on the left. Sketch the graphs of Voltage vs. Time for the resistor and the capacitor below. b. What happens to the

    Words: 604 - Pages: 3

  • Premium Essay

    Aircraft Fuels

    Use of Electrical Power Systems: The use of electrical power as an alternative to drive the aircraft systems and its sub-systems that had earlier been driven by hydraulic, and mechanical systems is becoming a ruling trend in the aerospace industry. Devolopment in the power electronics provide the technology to improve the overall efficiency,functioning and safety of aircraft systems operation. The More Electric Aircraft (MEA) is being devoloped with a goal of distribution of electrical power across

    Words: 421 - Pages: 2

  • Free Essay

    Thesis

    Resonant Pulse Converters Chapter 11 (or 8) Prepared by Dr. Mohammad Abdul Mannan Assistant P f A i t t Professor, Department of EEE D t t f American International University - Bangladesh Disadvantages of PWM Controlled Switching Devices in Converters The disadvantages of PWM controlled switching devices in converters are as follows: 1. The devices are turned “on” or “off” at the load current with a high di/dt value, 2. The it h 2 Th switches are subjected t a hi h lt bj t d to high-voltage

    Words: 2631 - Pages: 11

  • Premium Essay

    Timeline

    Evolutions of the Telecommunication Industry Timeline 1. 1793 - The Chappe brothers established the first commercial semaphore system between two locations near Paris. 2. 1843 - FAX invented by the Scotch physicist Alexander Bain. 3. 1844 - Morse demonstrates the electric telegraph; Morse's first telegraph line between Washington and Baltimore opens in May 4. 1870 - Thomas Edison invents multiplex telegraphy. 5. 1876 - Alexander Graham Bell invents the telephone. 6. 1921 -

    Words: 281 - Pages: 2

  • Free Essay

    Powerco Generators

    Santiago Diaz Fin 301 Final Project The purpose of this report is to analyze the data constructed by PowerCo to determine the potential profit or loss of building a new power generator. Because of the increase in demand, the current power plant will not be able to supply the demand for electricity over the next 10-12 yrs. A proposal has been made, and this report will determine if a new power generator should be constructed. Present Value (Pv) of Expected cost, Cf=Cash flow Pv=Cft/(1+r)˄t

    Words: 450 - Pages: 2

  • Premium Essay

    Kelly Service

    Services would like to extend our appreciation for everything you do at the Boeing Corporation. It is my understanding that there is an opening for an internship in the electrical engineering field at your Ridley Park, Pennsylvania location. Working daily with graduates and potential graduates at DeVry University in the electrical engineering major, we feel that we have the perfect piece to your team member seeking puzzle. Luca Ruggiero has expressed interest in this internship and has applied

    Words: 309 - Pages: 2

  • Free Essay

    Mr, Engineer

    Semester Mean Grade B 2006 – 2009 Nyamagwa Boys High School K.C.S.E Mean Grade A- 2000-2005 Kibinyanchwa Primary School K.C.P.E 366 Marks PROFESSIONAL STUDIES April 2011 to date Dedan Kimathi University of Technology (BSc. Electrical and Electronic Engineering) Nov – Dec 2014 Professional application software like MATLAB, NI, Proteus, etc Sept – Nov 2011 CISCO Networking Nov. 2009 – Feb 2010 Enrolled at Chanebi Computer Training College WORKING EXPERIENCE

    Words: 305 - Pages: 2

Page   1 41 42 43 44 45 46 47 48 50