Analysis and Review Questions 1. Compare the currents obtained from calculation and simulation. Comment on the findings of the values. | Calculation | Simulation using Multisim | Simulation using Pspice | Current when RL = 50 ohms | 2.994 < 69.91 A | 2.994 A | 4.273 A | Current when RL = 200 ohms | 2.306 < 47.92 A | 2.306 A | 3.277 A | Table above show the results of current obtained from the experiment and simulation. There is a different result between simulation using pspice
Words: 927 - Pages: 4
Lab #3: Controlling Currents 09/18/13 Objective- The first objective in this lab is to determine how a light bulb behaves in different circuit arrangements. The second objective investigates how the voltage across the light bulb varies with the amount of current through it. Finally, the last objective is to explore how the length of a wire affects resistance. Procedure- Activity 1 A) Measure the voltage across an open-circuit cell by connecting the positive terminal of the voltmeter
Words: 1508 - Pages: 7
11/5/2004 Noise Margins 1/12 Noise Margins The transfer function of a digital inverter will typically look something like this: vO V+ d vO = −1 dv I Transition Region d vO = −1 dv I vO = f (vI ) I III II V+ vI Note that there are essentially three regions to this curve: I. The region where vI is relatively low, so that the output voltage vO is high. II. The region where vI is relatively high, so that the output voltage vO is low. III. The transition region, where the input/output
Words: 1599 - Pages: 7
Ward-Leonard Motor Generation System Introduction: A control system generally controls, regulates, and updates its output continuously based on present inputs, nature of the system, and the past outputs. In other words, there is a feedback mechanism that is inherent in the system, and is called a closed loop control system. For example, adding an emitter resistance to a common emitter amplifier, results in a negative feedback mechanism in the amplifier system – if the output current increases
Words: 2302 - Pages: 10
their ability to perform thousands of tasks in the blink of an eye, none of these devices even come close to rivaling the computing capabilities of the human brain. At least not yet. But a Boise State University research team could soon change that. Electrical and computer engineering faculty Elisa Barney Smith, Kris Campbell and Vishal Saxena are joining forces on a project titled “CIF: Small: Realizing Chip-scale Bio-inspired Spiking Neural Networks with Monolithically Integrated Nano-scale Memristors
Words: 780 - Pages: 4
Bachelor of Science , Electrical & Electronics Engineering (2013) Major: Power system Bangladesh University of Engineering and Technology CGPA:2.88 out 0f 4.00 Higher Secondary Certificate (2007) Rajshahi New Govt. Degree College GPA: 5.00 out of 5.00 Secondary School Certificate (2005) Govt. Laboratory High School, Rajshahi GPA: 5.00 out of 5.00 March, 2013 to present O&M Solutions Bangladesh Limited, Dhaka, Bangladesh A Subsidiary of O&M Solutions, Mauritius Electrical Engineer EMPLOYMENT
Words: 681 - Pages: 3
B.E. (KU), 1998 M.E. (Electrical Power), NORAD/ KU, 2006 1998-2000 Lotus Energy 2000- Present Nepal Electricity Authority Distribution and Consumer Services 4/4/2007 1 Introduction OBJECTIVE OF COEG 303 Introduce Power Systems Modeling a Transmission Line Introduce a Distribution System Introduce Insulation requirements Mechanical Design of Transmission Line High Voltage DC Transmission Cables Corona Discharges 4/4/2007 2 Introduction to Power Systems Electrical power is a little bit
Words: 1089 - Pages: 5
Environnement, is selected for France's future investments program' <http://www.veolia.com/en/medias/press-releases/reflexe.htm> acessado em 23.7.2011 às 11h31 [3] National Smart Grid Policy: Moving Toward a National Modernized Electrical Grid through Current Pilot and Demonstration Programs <http://pip.collegethink.com/media/files/papers/Scott_09_r.pdf> acessado em 23.7.2011 às 11h46 "O que foi projetado para atender a uma realidade do século XX, seguramente não conseguirá
Words: 598 - Pages: 3
involved in is the ordering, tracking, manufacturing, and delivering of our high voltage transformers. This is a very important part of our company because these machines are of high cost and a vital part of the electrical engineering process. A transformer is a device that transfers electrical energy from one circuit to another through inductively coupled conductors. It is used to “step up” and “step down” the voltage of electricity as it moves between lines, substations, plants and buildings.
Words: 605 - Pages: 3
corrosion rate, which is accelerated by stray current interference, and the acceleration factor are most influential. Therefore these parameters will be assessed specifically, using reliability analysis tools. 2. Stray Current Corrosion Model An electrical circuit analogue, devoid of the spatial distribution of the problem, of traction power induced stray current interference is given in figure 1. RW 1. Introduction Contact wire path Rint Traction power systems leak currents into the
Words: 2699 - Pages: 11
