4A. Vesicular transfersome and liposome based transdermal gel of aceclofenac: 4A.1 Preformulation studies: Identification of drug was carried out by DSC, FTIR and UV spectrophotometry 4A.1.1 DSC studies-DSC studies were carried out at a temperature range of 25 º C to 165 º C at 10 º C increments of temperature. Figure4A.1-DSC Thermogram of Aceclofenac DSC thermogram indicates the M.P of 154º C which fairly matches with reported M.P of Aceclofenac, thus confirming the identity and
Words: 996 - Pages: 4
that describes the phase spectrum. Starting with the zero phase wavelet that effect of increasing amounts of the linear phase shift on a zero-phase wavelet. Although it is not changing the sign of the slope in the phase spectrum the wavelet that can be shifted in the opposite time direction. Rc = V 2 ρ 2 − V 1 ρ 1 / V 2 ρ 2 + V 1 ρ 1 2.2 where V 1 , ρ 1 and V 2 , ρ 2 are the velocities and densities of the upper and Lower layers. If a 90-degree
Words: 1167 - Pages: 5
Fig. 11 shows a single stage circuit diagram of the bi-directional Ćuk converter balancing system. Generally, the method uses n - 1 SMs to balance a series string of n battery cells where each SM is composed of two switches, two inductors, and one capacitor. Each SM is connected across two adjacent cells to allow energy transfer from the cell with a higher voltage to the cell with a lower voltage, so it takes a relatively long equalization time especially for long string battery packs. The voltage
Words: 412 - Pages: 2
Body 2 and move the bodies closer to a final separation d. if the capacitance coefficients are known, the system potentials can be calculated: Q_1=c_11 V_1''+c_12 V_2 Q_2=c_12 V_1''+c_22 V_2 The solution of these equation yields: V_2=(Q_2 c_11-Q_1 c_12)/(c_11 c_22-c_12^2 ) V_1''=(Q_1 c_22-Q_2 c_12)/(c_11 c_22-c_12^2 ) V_1^''-V_2=(Q_1 〖[c〗_22+c_12]-Q_2 〖[c〗_11+c_12])/([c_11 c_22-c_12^2]) CONDUCTION CHARGING CONTACT WITH FLOATING CHARGED CONDUCTOR A third type of charging can occur between two conductors
Words: 1585 - Pages: 7
M.R.I Anatomy Axial, sagittal and coronal image planes are commonly used for foot and ankle examination. Axial images: Fig. 3-1 Sagittal localizer for axial cuts: perpendicular to the long axis of the tibia (Berquist, 2012) In the axial plane, the low signal intensity bands of the anterior and posterior tibiofibular ligaments are demonstrated at the level of the tibial plafond. The inferior extensor retinaculum is identified anterior to and at its attachment to the medial malleolus
Words: 1003 - Pages: 5
Experiment 9: Reflection, Refraction, and Total Internal Reflection Purpose: The purpose of this experiment was to study the laws of reflection, refraction and total internal reflection, to measure the focal length of mirrors with convex and concave mirrors, and to measure the index of refraction of water. Theory: In this experiment, we learned that the angle of incidence θi is the angle that the incident ray makes in regards to the normal one. Also, the angle of reflection θr is the angle
Words: 1433 - Pages: 6
New Structure – Optical Networks The new structure has been given a grant to make its network state of the art by making it a fiber optic network. This paper will include what hardware will be necessary for the inside of the building and outside of the building and how we would expand the fiber to an adjacent building if it is built. This paper will also describe the safety procedures that will be followed during the fiber installation. INSTALLATION HARDWARE PULLING EYE- When running a cable through
Words: 1252 - Pages: 6
In microbiology lab different tests are performed for the diagnosis of different disease .they are used different techniques for the detection of presence of microorganism which are causing harmful disease Different test performed are • Test performed by ELISA technique a. Hepatitis B,C , b. Rheheumatoid arthritis (RF FACTOR ) c. Treponemapallidiumhaemagglutination test (TPHA) • Test performed by latex test a. CRP ( C reactive protein test ) b. ASO(anti - streptolysin o ) • Flocculation
Words: 540 - Pages: 3
In testing phase, the test image is the LR input image Y, obtained from TV decomposition technique. The LR input image Y is upsampled by the necessary scaling factor s. Form the overlapping patches P for upsampled image and convert them into vector to minimize the artifacts. The sparse representation of the LR input image αs can be obtained using the LR input patches P and the trained LR dictionary as input to the OMP algorithm. The trained HR dictionary D_il is updated by αs to obtain the updated
Words: 541 - Pages: 3
1. Scan converting a circle Circle is one of the most widely used shape in drawing pictures and graphs and in computer graphics, various procedures are developed to draw complete circles or any portion of it such as arcs and sectors. A circle is such a geometric shape that is defined by a center position and a fixed distance from the center which is called radius. It is drawn by combining all the points that are at a fixed distance from the center. Scan converting a circle requires each point
Words: 1907 - Pages: 8
