titration but it is more than required value as per literature value is concerned (0.40 g). The almost same percentagedifference occurs for next two trials (1.9 % and 2.5 %). The KHP is always 99.9 % pure, so the titration should give perfect results (Lab Manual). The other possible
Words: 598 - Pages: 3
MAE 361 MATERIALS AND PROPERTIES LABORATORY TORSION TEST Your lab report should be typed with a font of 12 and have the different sections clearly labeled It is important to follow the lab report format given in this document. If the format is not followed 10% of your score will be deducted. When you finish writing this report you should have learned about Torsion Test. A quiz will be given when you turn in your lab report. You should know the following: * What is torsion test
Words: 635 - Pages: 3
Emma Wellington Period 8 10/22/12 (No Partner) Lab #3 Separating the Components of a Mixture I. Purpose: The purpose of this lab was to separate the sodium chloride-silicon dioxide mixture using filtration and evaporation II. Equipment and Materials: Refer to the College Preparatory Lab manual, Page 28-30 III. Procedure: Refer to the College Preparatory Lab manual, page 28-30 IV. A. Measurements; Measurements and Data for Separating the Components
Words: 515 - Pages: 3
2-4: Precipitation Reactions 1. Start Virtual ChemLab and select Precipitation Reactions from the list of assignments. The lab will open in the Inorganic laboratory. 2. React each of the cations (across the top) with each of the anions (down the left) according to the data table using the following procedures: Data Table | |AgNO3 (Ag+) |Pb(NO3)2 (Pb2+) |Ca(NO3)2 (Ca2+) | |Na2CO3 (CO32-)
Words: 748 - Pages: 3
Mason Comia NT1310 Physical Networking Unit 4 Lab April 15th 2014 NT1310 Unit 4 Lab: Building a New Structure When it comes to designing a building, it is not just all about the carpentry or the drafting and design. Yes these resources are useful but they are both based on the cable infrastructure of the building. Especially for a computer science and electrical engineering lab that requires a ton of cabling from CAT6 and RJ45. The main cable that will be used in the buildings infrastructure
Words: 426 - Pages: 2
assignment, you will dissolve a sample of NaCl in water and then measure the boiling point elevation for the solution. 1. Start Virtual ChemLab and select Boiling Point Elevation from the list of assignments. The lab will open in the Calorimetry laboratory with a calorimeter on the lab bench and a sample of sodium chloride (NaCl) on the balance. 2. Record the mass of the sodium chloride in the data table. If it is too small to read, click on the Balance area to zoom in, record the reading
Words: 692 - Pages: 3
Jacqueline Kang 2-15-2015 Bio 203 Lab Measurement of Acid Phosphatase Activity Under a Variety of Environmental Conditions Introduction: Biological enzymes are very important as they allow the human body to function and produce a wide variety of biochemical reactions that help sustain life. The main purpose of this lab is to understand the narrow optimal range and varying perimeters that allow these enzymes to optimally function. The enzyme, acid phosphatase, and the substrate p-nitrophenylphosphate
Words: 939 - Pages: 4
Abstract In this lab we tested the contamination of water using oil, vinegar, and soap. Using plain tap water I added various amounts of contaminants to the water and noted the change. Introduction The introduction should describe the background of water quality and related issues using cited examples. You should include scholarly sources in this section to help explain why water quality research is important to society. When writing this section, make sure to cite all resources in
Words: 672 - Pages: 3
ITT Networking Standards & Protocols Midterm | Term First Both Sides How many bits are in a gigabyte?1 billion | Click to flip | | 50 terms Terms | Definitions | How many bits are in a gigabyte? | 1 billion | How many bits are in a megabyte? | 1 million | Convert 00101010 to decimal. | 42 | What is the difference between a sector and a track? | A sector is part of a track | How many bits are in one hexadecimal digit? | 4 | How are voice communications converted to digital
Words: 772 - Pages: 4
Lab Report Chemistry 341L: Preparation of Cyclohexene Introduction: The purpose of this lab was to prepare an alkene, cyclohexene, by the dehydration of an alcohol, cyclohexanol. In this experiment cyclohexanol is dehydrated to prepare cyclohexene, using phosphoric acid as a catalyst. Unsaturation tests are then done to ensure cyclohexene was prepared. Experimental Scheme: The procedure for the Preparation of Cyclohexene lab started with first having to add 10mL of cylcohexanol (clear liquid
Words: 1724 - Pages: 7
