1.0 Experiment 1: Effect of Controller Gain (P-value) Figure 1: Simulink setup for Experiment 1 Graph 1: Graph from value P = 0.005, I = 0.01 and D = 0 Graph 2: Graph from increasing value of P = 0.01 and fixed value of I = 0.01 and D = 0 Graph 3: Graph from increasing value of P = 0.02 and fixed value of I = 0.01 and D = 0 Graph 4: From combining Graph 1-3 to compare the result. From the simulation, the value of P in PID causes the graph change. Increasing the value of P makes the
Words: 1059 - Pages: 5
internal controls in place. The analysis and recommendations presented below are based on the internal control report. Question 1. Where is the theater’s control system lacking? Are the controls themselves weak or incomplete, or are the theater’s problems caused primarily because of lack of discipline in using the existing controls? Leo’s Four-Plex has four internal controls in place. These controls are presented in Table 1. Even though there are internal controls in place, the controls are not
Words: 903 - Pages: 4
instructions from his supervisor because he didn’t feel the need to follow instructions. Regarding the October 18th incident, management explained that Mr. Weber approached the bridge too fast, entered at an angle, he had crossed ¾ of the way across the bridge before the plow dug in, debris was thrown at about 100 feet, and the bridge was in good condition. Management describes the incident as being “pretty violent” in lieu of the evidence. Mr. Weber failed to safely operate
Words: 1218 - Pages: 5
tenaga kerja lebih rendah iii. Produk berkualitas 2. What are the most important aspects of Nucor’s overall approach to organization and control that help explain why this company is so successful? How well do Nucor’s organization and control mechanisms fit the company’s strategic requirements? Struktu organisasi yang dianut adalah system desentralisasi sehingga keputusan lebih cepat dan efektif, tidak harus menunggu keputusan dari kantor pusat. Hal tersebut juga memberikan kemungkinan
Words: 847 - Pages: 4
of Internet and worldwide technologies as these systems were tightly integrated with business systems and became more exposed to cyber threats. Supervisory Control and Data Acquisition (SCADA) protocols are communications protocols designed for the exchange of control messages on industrial networks. A control system is a device or set of devices to manage, command, direct, or regulate the behavior of other devices or systems. By complexity, the reliable operation of modern
Words: 884 - Pages: 4
organization without integrating all the parts into a whole. First, it is important to understand what a good corporate strategy is. According to the authors, it is not a random collection of individual building blocks, rather a fully constructed system of interdependent parts. In order for the organization to thrive, executives must actively direct decisions about resources the corporation will develop, and the business in which it will compete. During this, the executives must make sure all elements
Words: 1697 - Pages: 7
Internal Controls Report To: CEO/President –LJB Company From: It is important to understand all internal control requirements before the company decides to go public. Internal control systems must cover five primary elements: controlled environment, risk assessment, controlled activities, information and communication and monitoring. The following are internal control requirement activities that LJB Company must implement and maintain to mitigate risk and loss. * Establishment of responsibility
Words: 557 - Pages: 3
Sarbanes-Oxley Act of 2002. This means that LJB would be required to maintain a system of internal control. The controls must be reliable and effective, which the executives and Board of Directors must monitor. Also, an outside auditor must confirm that the control systems are sufficient. Although there will be additional work on both designing, testing and auditing of controls if LBJ decides to go public, but the control system may result in money and time saved in the long-term regardless. Good practices:
Words: 629 - Pages: 3
stability/neuroticism, and openness to experience. * these traits indicate to management how an individual will behave in various situations Detail the feedback control loop, and suggest one (1) way that the organization can use the feedback control loop to determine whether management’s actions are motivating or demotivating. * Feedback control loop allows for clear communication between workers and management and it enhances performance * To check effectiveness of communication
Words: 508 - Pages: 3
Ch05 ControlSys-4e-A&S 03-21, 03-22-2013 Chapter 5 INDUSTRIAL CONTROL SYSTEMS REVIEW QUESTIONS 5.1 What is industrial control? Answer: As defined in the text, industrial control is the automatic regulation of unit operations and their associated equipment as well as the integration and coordination of the unit operations in the larger production system. 5.2 What is the difference between a continuous variable and a discrete variable? Answer: A continuous variable is one that is
Words: 1598 - Pages: 7
