...PM598 consists of three parts, which provide familiarization to processes associated with Contract and Procurement Management. • Part 1 (PP1) of the course project focuses on the first section of the RFP and entails selecting one of the three RFP procurement cases listed under the PP1 section and using the PP1&2 - Course Project RFP Template document in the Doc Sharing area to develop information to support section one of the RFP. • Part 1 (PP2) of the course project entails completing the remaining sections of the RFP by developing a comprehensive document that could be submitted to a vendor. • Part 3 (PP3) of the course project entails selecting one of the three case studies from the PP3 - Course Project Case Study document in the Doc Sharing area and answering questions that demonstrate an understanding of the Garrett text. The deliverable for PP3 is a seven-page document that addresses each of the questions specified for the case study selected. This three-part project provides an overview of the processes and material that is used to develop a RFP as well as address relevant questions that could result from Contract and Procurement management. The points assigned to each part of the course project are listed below: |Course Project Assignment | Due |Points | | Course Project Part 1 (PP1) |Week 2 |40 | | Course Project Part 2 (PP2) |Week 4 |125 | | Course Project Part 3 (PP3) ...
Words: 2420 - Pages: 10
...Unit 6 Key Concept 1: Cable Connector Installation Copyright 2012, ITT ESI 1 Certification Process ◦ ◦ ◦ ◦ Test connections Verify cable performance Inspect environment Certification Copyright 2012, ITT ESI 2 Test Copper Connections ◦ Verify pinout ◦ Verify crimp ◦ Verify UTP not untwisted more than ½ inch Test Fiber Connections ◦ Verify seal ◦ Verify adhesion ◦ Visual inspection Copyright 2012, ITT ESI 3 Copper Cable Tests ◦ Wire mapping: Open Pair Shorted Pair Short between pairs Reversed pairs Crossed pairs Split pairs Copyright 20102 ITT ESI 4 Copyright 2012, ITT ESI 5 Copper Cable length ◦ Time Domain Reflectomoter (TDR) Introduces signal on an open cable and measure time for reflection of signal to return Measurement is compare to the nominal velocity of propagation (NVP) as specified for the cable Can also be used to find distance to a cable break ◦ Cable resistance Can be measured with a digital multimeter in ohms Measurement is compared to cable specification Copyright 2012, ITT ESI 6 Copper Performance Testing ◦ Impedance – Structural Return Loss (SRL) measured in decibel (db) ◦ Attenuation – transmitter and received determine signal loss in db ◦ Near End Crosstalk (NEXT) – transmitter and receiver measure jumped signals near source ◦ Far End Crosstalk (FEXT) - transmitter and receiver measure jumped...
Words: 1538 - Pages: 7
