how much aquatic life can be supported within an environment (Metro 1990). Along with having the correct amount to Hydrogen ions, both the stream and the wetland have a level on dissolved oxygen level. This level is measured to the amount of oxygen gas bubbles within the water that the aquatic life uses to sustain itself. This oxygen is also used to decompose of organic matter (Metro 1990). The purpose of this experiment is to test to determine to what levels of both pH and dissolved oxygen are processed
Words: 398 - Pages: 2
of water. * Temperature (100°C): It is important to acknowledge that the temperature at which water boils is 100°C. This is controlled by how much gas and fire is released from the Bunts & Burner. * Time (seconds): The time is highly important. Time is controlled by how much gas is released from the Bunts & Burner. The lower the gas, the longer it will take for the water to boil due to low heat. SCOPE AND LIMIT The range of your measurements (from x to y) and the size of the increments
Words: 328 - Pages: 2
of heating and cooling. Water enters at the end of the tube. The thermometer is placed inside the distilling flask. Anti-bumping granules are used to provide many places where bubbles of gas may form as the water boils. The bubbles are small and rise steadily to the surface of the liquid where they burst. Without the granules, fewer but larger bubbles form. They rise and burst with such force that they shake the test tubes which can be
Words: 280 - Pages: 2
Grade: Opaque, white tape. Odor threshold Not Applicable pH Not Applicable Melting point Not Applicable Boiling Point Not Applicable Flash Point Not Applicable Evaporation rate Not Applicable Flammability (solid, gas) Not
Words: 436 - Pages: 2
what occurs when heat is added or removed from a substance and how to calculate the enthalpy change. Answer In a gas, the potential energy (energy of attraction) is small to the kinetic energy thus, on average, the particles are far apart. This large distance has several macroscopic consequences : a gas fills its container, is highly compressible, and flows easily through another gas. In a liquid , attractions are stronger because the particles are touching, but they have enough kinetic energy to
Words: 1415 - Pages: 6
Solubility is the property of a solid, liquid, or gaseous chemical substance called solute to dissolve in a solid, liquid, or gaseous solvent to form a solution of the solute in the solvent Solubility is defined as the ability of one substance to dissolve within another substance. What Affects Solubility? One of the factors that has a profound impact on solubility is temperature. Temperature, a measure of the available thermal energy, can increase the solubility of solids in liquids. This phenomenon
Words: 825 - Pages: 4
metabolic rate by allowing the organism to interact with changing temperatures form 5oC to 40oC. In the laboratory, the animal was placed in a closed chamber, were the flow of gases was recorded, and the change in Oxygen intake was recorded using a gas sensor. Indirect calorimetry was employed. The data outcome shows a linear relationship between the animal’s body temperature and the ambient temperature, while also showing a small exponential relationship with steady increments of both the O2 consumption
Words: 1431 - Pages: 6
Laboratory Report The Rate of Reactions Abqari Afandi Grade 10 October 6th 2014 Purpose: To investigate the relationship between the temperatures of Hydrochloric acid with the duration of Magnesium ribbon to dissolve in the acid. Procedure: 1- Prepare four 400ml beaker: one for the hot bath, one for the room temperature, one for ice water bath and one for super hot bath. Fill all beakers half-full. Put one on a hot plate; the temperature of the water on the hot plate should not
Words: 654 - Pages: 3
Experiment #6 Determination of the solubility product of PbI2 Introduction: The purpose of this lab is to get familiar with the concept of solubility by determining the concentration of PbI2 and Pb2+ in the slightly acidic solution and to calculate the solubility constant using the equation Ksp=[Pb2+][I-]2 . Safety: Safety glasses must be worn at all times. Gloves are recommended in order to avoid the direct contact between skin and the chemicals. Avoid the spill of chemicals during shaking
Words: 491 - Pages: 2
where pIGN represents the unburned gas pressure measured at spark ignition time, TIGN its temperature, evaluated by the use of equation (5), while m is the polytropic coefficient: this has been determined as the opposite slope of least square regression line representing Log p as function of Log V from 80 to 40 crank angle degrees before TDC. This procedure, applied to each single pressure trace, allowed taking into account the different heat transfer levels related to the several different compression
Words: 1016 - Pages: 5
